Enterasys Networks CSX7000 Manuel d'utilisateur télécharger pdf (Page 489)

100

101

Central Site Remote Access Switch 489

YSTEM

ESSAGES

System Message Summary

Bridge is operating in RESTRICTED mode

Bridge is operating in UNRESTRICTED mode

One of the above messages will be displayed to indicate the configured Bridge mode of operation.

Calculating CRC’s.....

An X-Modem transfer has been completed and the received data is being checked for integrity.

Callback type <call back type ID> is not currently supported.

During callback negotiation between the CyberSWITCH and the remote device, an unsupported

type of callback was received.

Call control detected near end problem - Slot=<slot #> Port=<port #>

The system detected a problem when initiating a call over the indicated line. The call will be retried

over a different line if possible.

Call_ID in use in HOST_CALL_REQUEST

An error has been detected in the R2 or RBS signaling procedure, which typically results in a failed

call. Contact your Distributor or Customer Support.

Calling Line ID Failure, Duplicate ID - <calling line Id>

A call has come in for a device that is using Calling Line Id (CLID) as the only authentication

method, and the given CLID is not unique across all devices.

Calling Line ID Security Failure <calling line Id>

The system has rejected a device due to a mismatch between the Calling Line Id presented by the

caller and the Calling Line Id in the on-node device database or obtained via an off-node

authentication server such as RADIUS.

Calling Line ID Security Failure <calling line Id>, Device: <device name>

The system has rejected a device due to a mismatch between the Calling Line Id presented by the

caller and the Calling Line Id in the on-node device database or obtained via an off-node

authentication server such as RADIUS. The device’s name is also contained within the database.

Calling Line ID Security Failure - off-node authentication server not supported

The system authentication type is configured to obtain device information off-node, for example

from a RADIUS server; however, such transactions are not yet supported when Calling Line Id

Security is enabled.

Call Rejected, Maximum Bandwidth already in place to Device Id <device Id>

An incoming call was rejected because the Maximum Data Rate parameter was exceeded for the

indicated device. The Maximum Data Rate parameter can be configured for PPP devices under the

configuration utility CFGEDIT or through the Manage Mode.

Call Rejected, No Called TN IE

The switch did not deliver an Information Element for the call. This problem normally occurs if you

are connected to a point-to-point line and have the System configured for a multipoint line. If you

are connected to a multipoint line and get this message, call your phone company and report the

problem.

Call Restrictions have been disabled by user command

The user has disabled Call Restrictions via the

callrest off

Dynamic Management command.

1 2 ... 484 485 486 487 488 489 490 491 492 493 494 ... 728 729

Commentaires sur ces manuels

Pas de commentaire

Enterasys Networks CSX7000 Manuel d'utilisateur Page 489

Commentaires sur ces manuels