Enterasys Networks CSX7000 Manuel d'utilisateur télécharger pdf (Page 103)

100

101

Central Site Remote Access Switch 103

CCESSING

THE

YBER

SWITCH

Establishing an Administration Session

ESTABLISHING AN ADMINISTRATION SESSION

If a login prompt is displayed after the power-on initialization, the system software was preinstalled.

Complete the login:

1. The login controls which class of commands the user can access. Each access level (guest or

administrator) is protected by a unique login password. This allows managers to assign

different responsibility levels to their system users. Enter the following login:

admin

Note: When using off-node authentication, administration access level actually supports up to

101 different login names, from admin and admin00 to admin99. These different login

names must be configured on the off-node server in order to function properly. For

local administration access, only the guest and the singular admin login access levels are

valid.

2. All preinstalled systems are preconfigured with the same password. This is the password that

is used the first time a login occurs. Using all lowercase letters, enter the preconfigured

password as shown below:

admin

3. It is recommended that the preconfigured password be changed to a user-defined password.

To do this, enter the following command at the system prompt:

pswd

Follow the prompts to change the current password. A password must be a 3 to 16 nonblank

character string. Passwords are uppercase and lowercase sensitive.

Note: User-level security is not available at time of initial installation and configuration.

However, once this option is configured, you will have additional security steps before

establishing an administrative session. Refer to Responding to LOGIN Prompts in the

Configuring Security Level chapter for more information.

If a DOS prompt is displayed after the power-on initialization, the software has not been preinstalled.

You must first boot up with diskette #1 before continuing:

1. Insert software diskette #1 into the system diskette drive.

2. Reboot the CyberSWITCH.

At this point, if you need to install new or upgraded software, refer to the Upgrading System Software

chapter. If software has been preinstalled by your distributor, skip to Configuration Tools chapter to

begin the configuration process.

1 2 ... 98 99 100 101 102 103 104 105 106 107 108 ... 728 729

Commentaires sur ces manuels

Pas de commentaire

Enterasys Networks CSX7000 Manuel d'utilisateur Page 103

Commentaires sur ces manuels