Enterasys Networks CSX7000 Manuel d'utilisateur Page 371

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 729
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 370
Central Site Remote Access Switch 371
C
ONFIGURING
C
ALL
C
ONTROL
Call Interval Parameters
CALL INTERVAL PARAMETERS
CONFIGURING THE CALL INTERVAL PARAMETERS
USING CFGEDIT
1. Select Call Intervals from the Call Control Options menu.
2. Enter the minimum time interval between call attempts.
CALL INTERVAL CONFIGURATION ELEMENTS
MINIMUM TIME INTERVAL
The configured call interval is the minimum time between call attempts. The system will not make
a call attempt in less than the configured call attempt value. However, due to the system hardware
clock resolution, the actual time interval may be greater than the configured value. The default
value is 0.70 seconds. The range of the configured value is 0 to 5 seconds, in 1/100 second
increments. A configured value of 0 implies that the system will make call attempts without any
delay between them.
CALL INTERVAL BACKGROUND INFORMATION
This parameter allows the configuration of the minimum interval between call attempts. This
interval applies to the entire system, including all lines, sites, and devices.
The Call Interval is configured in terms of hundredths of seconds. The default value is .7 seconds.
The range of the configured value is 0 to 5 seconds. A configured value of 0 implies that the system
will make call attempts without any delay between them.
The default value of .7 seconds is compliant with the Communications Industries Association of
Japan’s(CIAJ) regulation. This regulation states that no customer premise equipment should make
more than 3 call attempts within 2 seconds. This prevents certain model switches from being
overloaded. In areas where these low capacity switches are not installed, calls can be made more
frequently.
Before the system initiates a data connection, it first checks the time at which the last connection
was initiated. If the time from the last connection attempt to the new connection attempt is less than
the configured call interval, the new connection is placed on an outgoing call queue. The queue is
then serviced at the configured call interval.
MONTHLY CALL CHARGE
CONFIGURING MONTHLY CALL CHARGE
USING CFGEDIT
1. Select Call Charges from the Call Control Options menu.
2. Follow the onscreen instructions to enable this feature.
3. Enter the maximum monthly charge you would like to set (specified in Yen for NTT
connections).
4. Select the action to take if the maximum is exceeded.
Vue de la page 370
1 2 ... 366 367 368 369 370 371 372 373 374 375 376 ... 728 729

Commentaires sur ces manuels

Pas de commentaire