Enterasys Networks CSX7000 Manuel d'utilisateur Page 99

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 729
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 98
Central Site Remote Access Switch 99
A
CCESSING
THE
C
YBER
SWITCH
Making Connections
6. Turn on the CyberSWITCH by pressing the POWER-ON button.
7. Turn on the monitor.
8. After a few seconds, power-on initialization will begin. Proceed to Establishing an
Administrative Session.
NULL-MODEM CONNECTION TO A PC
If you wish to use an IBM-compatible PC to locally administer your system, you will need to
establish a null-modem connection between PC and CyberSWITCH. You will also need the
optional Manager diskette which includes Carbon Copy software. Carbon Copy allows you to
manage and configure your CyberSWITCH as if it were a direct connection, and additionally
provides a means for file transfer. Refer to the Carbon Copy discussion in the Remote Management
chapter for more information.
Physical Connections:
1. Use a null-modem cable (with 9-pin female RS232 connectors) to connect the 9-pin, male RS232
port on the CyberSWITCH to the 9-pin, male RS232 port on the PC. Depending on the type of
administration console PC you use, the null modem pin-outs may vary. The following are
appropriate connections:
2. On the PC, execute the Manager software from diskette, or install the software on your PC’s
hard disk and execute from hard disk. (1 MB of free space needed for installation.) Note that
hard disk operation is more efficient.
Note: You do not need to change Carbon Copy’s port parameters. The default values are sufficient
for null-modem connection.
Powering On:
1. Verify that the line voltage select switch is set for the correct AC input power source.
2. Plug the standard power cord into the CyberSWITCH’s AC input power socket.
3. Ensure that the POWER-ON button on the CyberSWITCH is in the OFF position.
CyberSWITCH to IBM AT CyberSWITCH to IBM PC
DCD
DSR
RCV
XMIT
DTR
GND
RTS
CTS
DTR
RCV
XMIT
DCD
DSR
GND
RTS
CTS
1
6
2
3
4
5
7
8
4
2
3
1
6
5
7
8
DCD
DSR
RCV
XMIT
DTR
GND
RTS
CTS
DTR
RCV
XMIT
DCD
DSR
GND
RTS
CTS
1
6
2
3
4
5
7
8
20
3
2
6
8
7
4
5
Vue de la page 98
1 2 ... 94 95 96 97 98 99 100 101 102 103 104 ... 728 729

Commentaires sur ces manuels

Pas de commentaire