Enterasys Networks CSX7000 Manuel d'utilisateur télécharger pdf (Page 446)

100

101

USER’S GUIDE

446 CyberSWITCH

The same example that is used in the previous section is used to verify IP RIP input processing on

a WAN interface.

1. Make sure that a dedicated connection between system and Router is up and operational. On

the CyberSWITCH administration console:

Type:

2. Determine if system has learned the route to 192.1.2.0 from the Router. On the CyberSWITCH

administration console:

Type:

ip route

If the route to 192.1.2.0 is displayed, the IP RIP input processing is operational.

3. If the route is NOT displayed, try the following:

a. Verify that the IP RIP Receive Control is set to the proper RIP version that the Router

is using. Refer to page 443 for instructions regarding check RIP versions.

b. Enter the

ip rip stats

administration console command. Look for the

IfStatRcvResponses counter for the interface. This statistics is the number of RIP update

messages received on the interface. If the total number of these counters is 0, check the

Router to verify that it is configured to send IP RIP update messages.

c. Also look for the IfStatRcvBadPackets and IfStatRcvBadRoutes counters.

• If these counters are not 0, there may be something wrong with the Router.

• If these counters are 0, there is an unexpected condition present within the

CyberSWITCH system software. Contact Customer Support.

IPX

IPX ROUTER INITIALIZED?

1. Determine if IPX routing has been initialized on the CyberSWITCH by viewing the system

messages. To display the messages enter the following console command:

2. Look for the following IPX message among the system messages:

[IPX] IPX router is initialized successfully

Also, for each IPX interface that has been configured, the following interface initialization

message should be displayed among the system messages.

[IPX] Network initialized successfully on xxxxxxxx:xxxxxxxxxxxx

Note: Other messages may also be displayed with the IPX router initialization messages.

If you see these IPX router initialization messages, the IPX router is initialized.

3. If these IPX router initialization messages are NOT displayed, look for the following message:

[IPX] Initialization failure

This message indicates an internal error. Contact Customer Support

1 2 ... 441 442 443 444 445 446 447 448 449 450 451 ... 728 729

Commentaires sur ces manuels

Pas de commentaire

Enterasys Networks CSX7000 Manuel d'utilisateur Page 446

Commentaires sur ces manuels