Enterasys Networks CSX7000 Manuel d'utilisateur télécharger pdf (Page 245)

100

101

Central Site Remote Access Switch 245

ONFIGURING

LTERNATE

CCESSES

X.25 Accesses

4. Enter the X.121 address of the local DTE (the CyberSWITCH).

5. Select the data rate for the line.

6. Enter a list of bearers (a channel map). For PRI lines, the range of channels is from 1 to 24. For

BRI lines, the range of channels is from 1 to 2. Separate bearer channels by commas, and/or list

a range by using a dash (-).

LAPB C

ONFIGURATION INFORMATION

1. Enter the LAPB sequence number range to use, regular, or extended. Extended sequence

numbering allows for frames to be assigned sequence numbers from 0-127 (modulo 128), as

opposed to 0-7 (modulo 8).

2. Enter the duration of Timer T1, which is the maximum time to wait for responses to pending

commands.

3. Enter the duration of Timer T3, which is used to signal that an excessively long idle time is

occurring on the link. LAPB requires that Timer T3 be greater than Timer T1.

4. Enter the maximum number of frame re-transmissions that can be performed (this is

commonly known as “N2”).

5. Enter the maximum number of frames that the transmitting station may have outstanding at

any given time (this is commonly known as “K”). The range for this parameter will be 1-7 if the

Modulo 8 sequence numbers are being used for LAPB, or 1-127 if Modulo 128 sequence

numbers are being used.

X.25 C

ONFIGURATION INFORMATION

1. Configure the X.25 Logical Channel Assignments. This requires entering the maximum

number of PVCs and SVCs to be supported. For X.25 over B-channel, a total of 48 virtual

circuits are supported; over D-channel 8 virtual circuits are supported. Therefore, the total

number of PVCs and SVCs combined cannot exceed the maximum number of VCs.

a. Enter the maximum number of PVCs to support.

b. Enter the maximum number of SVCs to support.

2. Configure the X.25 Timers.

a. Enter the duration of Timer T20.

This timer designates the time limit in which a restart confirmation must be returned by the

DCE (the PPSN) after a restart request has been issued by the DTE (the CyberSWITCH).

b. Enter the duration of Timer T21.

This timer designates the time limit in which a call connected response must be returned

by the DCE (the PPSN) after a call request has been issued by the DTE (the CyberSWITCH).

c. Enter the duration of Timer T22.

This timer designates the time limit in which a reset confirmation must be returned by the

DCE (the PPSN) after a reset request has been issued by the DTE (the CyberSWITCH).

d. Enter the duration of Timer T23.

This timer designates the time limit in which a clear confirmation must be returned by the

DCE (the PPSN) after a clear request has been issued by the DTE (the CyberSWITCH).

1 2 ... 240 241 242 243 244 245 246 247 248 249 250 ... 728 729

Commentaires sur ces manuels

Pas de commentaire

Enterasys Networks CSX7000 Manuel d'utilisateur Page 245

Commentaires sur ces manuels