Enterasys Networks CSX7000 Manuel d'utilisateur télécharger pdf (Page 468)

100

101

USER’S GUIDE

468 CyberSWITCH

c. If desired, enter MANAGE mode, and use the

dhcp change

command to enable the

Proxy Client. (Note: CFGEDIT can also be used to change the Proxy Client configuration;

but the changes will not take effect until the system is restarted.)

d. When Manage Mode is exited, an attempt will be made to enable the Proxy Client.

e. Re-examine the report log for the “Proxy Client Enabled” message.

f. Remember to “commit” the Manage Mode configuration changes to make them

permanent.

5. If an error occurred while trying to enable the Proxy Client, the following message may be

present in the report log:

[DHCP-P] Failed to register with the IP Address Pool Manager,

erc=<error code>

If this error message is found in the report log, it indicates that an internal error occurred while

the DHCP Proxy Client was trying to register as a provider of addresses for the IP Address

Pool. Therefore, the proxy client will not operate correctly. Contact your Distributor or

Customer Support.

VERIFYING THE PROXY CLIENT IS OPERATIONAL

Once the DHCP Proxy Client manager has been successfully initialized and enabled, it should

begin obtaining IP addresses from DHCP servers. The manager examines any WAN and WAN

(Direct Host) network interfaces. It then attempts to satisfy the “number of IP addresses to pre-

fetch” for each of these network interfaces.

ERIFICATION OF UDP PORTS

In order to reach DHCP servers, the DHCP Proxy Client will open the BOOTPC UDP port, and

possibly the BOOTPS UDP port. One or both of the following messages should then appear in the

report log:

[DHCP-P] UDP port (67) opened

[DHCP-P] UDP port (68) opened

If neither of these messages is found in the report log, try the following:

a. Check the DHCP-related configuration for WAN and WAN (Direct Host) IP network

interfaces which should have IP addresses obtained from DHCP servers for them. Use

CFGEDIT, or use the

ipnetif

command from Manage Mode. Correct if necessary.

b. Make sure that the maximum addresses to obtain for the interface is non-zero.

c. Make sure that the number of addresses to pre-fetch for the interface is non-zero.

d. The DHCP Server must be configured to distribute addresses to clients on the DHCP

Client’s subnetwork.

1 2 ... 463 464 465 466 467 468 469 470 471 472 473 ... 728 729

Commentaires sur ces manuels

Pas de commentaire

Enterasys Networks CSX7000 Manuel d'utilisateur Page 468

Commentaires sur ces manuels