Enterasys Networks CSX7000 Manuel d'utilisateur télécharger pdf (Page 435)

100

101

Central Site Remote Access Switch 435

ERIFYING

OUTING

ROTOCOLS

IP Routing Operational?

Below is an example of a configuration used to verify IP routing over a WAN interface. It uses IP

addresses specific to the example. Substitute the IP addresses of your network when you perform

the verification steps. It also uses the “ping” command. The “ping” command sends a packet to a

specified host, waits for a response, and reports success or failure. Substitute the equivalent

command on your IP host.

1. Determine if a remote IP host can access the WAN interface of the CyberSWITCH over the

WAN connection. On the remote IP host, type:

ping 192.100.1.1

If the remote IP host successfully pings to the CyberSWITCH, continue with step 3.

2. If the remote IP host CANNOT ping to the system, try the following:

a. Verify that the WAN connection is up. Use the

console command to display the

Connection Monitor display. Check for the connection. If the connection is up, continue

with the next step.

If the connection is NOT up, refer to the section titled Remote Device Connectivity.

b. Verify that the WAN interface is properly initialized. Use the

ipnetif

command (Manage

Mode) to check for the proper WAN interface. If it exists, continue with the next step.

If the proper WAN interface does not exist, make corrections to the system configuration

using CFGEDIT.

c. Check that the IP address configured in the Device list for the IP Host device matches the

address configured on the IP Host device. Make corrections to the CyberSWITCH’s

configuration (using the

iproute change

Manage Mode command), or to the IP Host’s

configuration, as required.

3. Determine if a remote IP host can access the LAN interface of the CyberSWITCH over the WAN

connection. On the remote IP host type:

ping 100.0.0.1

If the remote IP host successfully pings to the CyberSWITCH, then continue with the step 5.

192.100.1.1

100.0.0.1

100.0.0.0

Host A

100.0.0.2

Host B

192.100.1.3

ISDN

CSX5500

1 2 ... 430 431 432 433 434 435 436 437 438 439 440 ... 728 729

Commentaires sur ces manuels

Pas de commentaire

Enterasys Networks CSX7000 Manuel d'utilisateur Page 435

Commentaires sur ces manuels