Enterasys Networks CSX7000 Manuel d'utilisateur télécharger pdf (Page 242)

100

101

ONFIGURING

LTERNATE

CCESSES

OVERVIEW

An access defines the connection details the CyberSWITCH uses to reach the network. The default

access is ISDN access, a switched-network access. Configurable accesses are required for dedicated

network connections, and for packet-switched network connections including X.25 and frame relay

connections. Refer to the following information for the alternate access you wish to add.

DEDICATED ACCESSES

CONFIGURING A DEDICATED ACCESS

USING CFGEDIT

1. Select Access from the Physical Resources menu, then follow the onscreen instructions to add a

dedicated access.

2. Select the line Id of the line you will use for this access.

3. For BRI and PRI lines: select the bearer channels the access will use.

4. For V.35 or RS232 resources, select the clocking type (internal or external clocking).

5. For Internal clocking, select the access’ data rate.

6. For External clocking, enter the Data Rate in bits per second.

7. Select the line protocol. In almost all cases, select PPP. Select HDLC only if you are connecting

to a device that uses HDLC over a dedicated access.

8. Enter the device name tied to this access (optional for accesses using PPP protocol, mandatory

for accesses using HDLC protocol).

Note: Device authentication must be enabled for dedicated accesses to properly identify the

remote device and provide switched backup and overflow to that device. Remote devices

using a dedicated connection must use PPP for device authentication. Authentication

configuration is described in Security Configuration.

SING MANAGE MODE COMMANDS

dedacc

Displays previously configured dedicated accesses.

1 2 ... 237 238 239 240 241 242 243 244 245 246 247 ... 728 729

Commentaires sur ces manuels

Pas de commentaire

Enterasys Networks CSX7000 Manuel d'utilisateur Page 242

Commentaires sur ces manuels