Enterasys Networks CSX7000 Manuel d'utilisateur télécharger pdf (Page 597)

100

101

Central Site Remote Access Switch 597

YSTEM

OMMANDS

Compression Information Commands

COMPRESSION INFORMATION COMMANDS

Compression statistics are only available for connections that are using a compression protocol.

The following commands are used to display current compression information:

cmp stats

Displays the compression statistics for all active connections. Refer to Compression Statistics, for

a list of available compression statistics and their definitions.

cmp stats <device name>

Displays the compression statistics for the indicated device. Refer to Compression Statistics, for

a list of available statistics and their definitions. Note that the device name is case sensitive.

cmp clear <device name>

Clears the compression statistics for the indicated device. If the device name is omitted, no

compression statistics will be cleared. Note that the device name is case sensitive.

cmp clearall

Clears the compression statistics for all devices.

CSM COMMANDS

The primary service is selected through the Connection Services Manager (CSM) GUI. When

configuring services, you first add an entry for each service, then optionally configure managing

information to designate primary and secondary services for the network’s Access Servers. In the

past, a service would attempt to TCP connect to all Access Servers configured in its database. The

Access Server would consider the first service to TCP connect as its primary server. If that server

became no longer available, the next server to connect would take over, and so on. By configuring

managing information, you are able to designate a specific primary and secondary server. Refer to

CSM documentation for more information about using primary and secondary servers.

primcsm

Displays a message indicating whether or not a CSM is currently acting as a Primary Service.

One of two messages will be displayed:

The CSM currently being used as Primary is at: <IP address>.

There is currently no CSM connection established.

DHCP COMMANDS

These commands allow you to display or erase DHCP statistics.

DHCP stats

Displays the DHCP statistics. For a listing of available statistics and their definitions, refer to

DHCP Statistics.

1 2 ... 592 593 594 595 596 597 598 599 600 601 602 ... 728 729

Commentaires sur ces manuels

Pas de commentaire

Enterasys Networks CSX7000 Manuel d'utilisateur Page 597

Commentaires sur ces manuels