Enterasys Networks CSX7000 Manuel d'utilisateur télécharger pdf (Page 618)

100

101

USER’S GUIDE

618 CyberSWITCH

TELNET COMMANDS

These commands are Telnet client console commands. These commands provide tools for you

when you are using the system as a Telnet client. As a Telnet client, the CyberSWITCH can then be

used to Telnet into another CyberSWITCH to perform system maintenance, for example, updating

configuration information. These commands are not needed for a Telnet session as a rule, but may

be beneficial for some users. For more information regarding the system’s Telnet client feature,

refer to the Telnet section of the Remote System Management chapter.

telnet ?

Displays the help screen for the

telnet

command. The help screen provides the syntax for the

command described below.

telnet <ip-address> [port number]

Begins a Telnet session for the Telnet host at the indicated IP address. The port number is an

optional parameter that can be used to specify the destination port number. Include this

parameter if you wish to connect to a port other than the default port number, 23.

telnet

The telnet command used with no arguments, as opposed to the above command, puts you in

the Telnet command mode. Once you are in the Telnet command mode, the following

commands are then available.

Used to close the current Telnet connection to a target host.

exit

Closes the current Telnet session. If a connection exists to a target host, it is gracefully

closed.

open

Used to establish a Telnet session with a target host. You can enter the IP address of the

target host, and optionally, the remote port number, to connect to. If no remote port number

is specified, the default Telnet port is used (23). The valid range for port number is 1 to

65535. The IP address specified is verified for proper format.

If a Telnet session is successfully initiated as a result of the

open

command, a screen similar

to the following will be displayed:

If an IP address (and port) are not specified on the “open” command line, you will be

prompted for the target host’s IP address.

send [send parameter]

Used to send special Telnet control functions to the currently connected target host. A

connection must be fully established before you can send anything. If no parameters are

specified on the

send

command line, the following help message is displayed:

telnet>

open 204.157.42.150

Trying 204.157.42.150...

Connected to 204.157.42.150.

Escape character is ‘^]’.

1 2 ... 613 614 615 616 617 618 619 620 621 622 623 ... 728 729

Commentaires sur ces manuels

Pas de commentaire

Enterasys Networks CSX7000 Manuel d'utilisateur Page 618

Commentaires sur ces manuels