Enterasys Networks CSX7000 Manuel d'utilisateur télécharger pdf (Page 294)

100

101

USER’S GUIDE

294 CyberSWITCH

8. Select IP protocol. If you choose an upper-level protocol, refer to the three following

configuration sections: Configuring TCP, Configuring UDP, and Configuring ICMP.

ONFIGURING TCP

If you have selected TCP as your IP protocol, a screen similar to the following is displayed. Note

that the following TCP defaults constitute a wild card match for any TCP packet:

1. Select TCP Source Port. Note that the ports are specified in terms of an operator.

2. Select a comparison operator.

3. If you have chosen the comparison operator of “RANGE”, you will be prompted for upper-range

and lower-range values. If you have chosen a comparison operator other than “RANGE”, you will be

prompted for a specific TCP port number.

4. Select TCP Destination Port. Note that the ports are specified in terms of an operator.

5. Select a comparison operator.

6. If you have chosen the comparison operator of “RANGE”, you will be prompted for upper-range

and lower-range values. If you have chosen a comparison operator other than “RANGE”, you will be

prompted for a specific TCP port number.

7. Select TCP Control.

8. Specify a control value (any, established, or not established).

ONFIGURING UDP

If you have selected UDP as your IP protocol, a screen similar to the following is displayed. Note

that the following UDP defaults constitute a wild card match for any UDP packet:

PACKET TYPE "Type_One":

1) IP Source Address AND 0.0.0.0 EQUAL 0.0.0.0

2) IP Destination Address AND 0.0.0.0 EQUAL 0.0.0.0

3) IP Protocol EQUAL TCP

4) TCP Source Port RANGE 0 - 65535

5) TCP Destination Port RANGE 0 - 65535

6) TCP Control ANY

Select function from above or <RET> for previous menu:

PACKET TYPE "Type_One":

1) IP Source Address AND 0.0.0.0 EQUAL 0.0.0.0

2) IP Destination Address AND 0.0.0.0 EQUAL 0.0.0.0

3) IP Protocol EQUAL UDP

4) UDP Source Port RANGE 0 - 65535

5) UDP Destination Port RANGE 0 - 65535

Id of the item to change, <RET> to accept changes or <CTRL-C> to cancel

1 2 ... 289 290 291 292 293 294 295 296 297 298 299 ... 728 729

Commentaires sur ces manuels

Pas de commentaire

Enterasys Networks CSX7000 Manuel d'utilisateur Page 294

Commentaires sur ces manuels