Enterasys Networks CSX7000 Manuel d'utilisateur Page 347

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 729
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 346
Central Site Remote Access Switch 347
C
ONFIGURING
IPX
IPX-Specific Information for Devices
3. Select On-node Device Entries from the device level databases menu.
4. Press 1 to add a device.
5. Enter the device’s name and press <RET>. You should provide ISDN and Authentication
information first.
6. Select Bridging from the Device Table Menu. A menu similar to the following will be displayed:
7. Enable Bridging and disable Make calls for bridge data.
8. Select IPX Remote LAN Network Number. Provide the external network number for the Remote
LAN interface if desired. The default value, NONE, means the remote IPX external number will
be the default IPX Remote LAN interface network number. Refer to page 329.
Note: The IPX Spoofing Options selection for Remote LAN devices is for a future release. Do not
try to configure at this time.
U
SING MANAGE MODE COMMANDS
device add
Allows you to add a device entry to the Device List. You will be prompted for device
information, including IPX information.
device change
Allows you to change information for a specific device entry. This will allow you, for example,
to add IPX information to a previously configured device entry.
IPX CONFIGURATION ELEMENTS FOR DEVICES
IPX ROUTING
Indicates that the remote device is an IPX router and that the system should route IPX datagrams
to this device. The system will forward IPX datagrams to this device based on IPX network layer
information if this parameter is set to enabled. The system will not forward IPX datagrams to this
device based on IPX network layer information if this parameter is set to disabled.
M
AKE CALLS FOR IPX DATA
Indicates whether the CyberSWITCH should establish a WAN connection in order to forward IPX
datagrams to this remote device. If the CyberSWITCH is properly configured for dial out, and if the
remote device has IPX routing enabled and this Make Calls option enabled, then the CyberSWITCH
will establish a WAN connection to this remote device in order to forward IPX datagrams.
Device Bridging: (Device = "remote2")
1) IP (Sub)Network Number NONE
2) Bridging ENABLED
3) Make calls for bridge data DISABLED
4) IPX Remote LAN Network Number NONE
5) IPX Spoofing Options
6) AppleTalk Network Number NONE
Select function from above or <RET> for previous menu?
Vue de la page 346
1 2 ... 342 343 344 345 346 347 348 349 350 351 352 ... 728 729

Commentaires sur ces manuels

Pas de commentaire