Enterasys Networks CSX7000 Manuel d'utilisateur télécharger pdf (Page 220)

100

101

USER’S GUIDE

220 CyberSWITCH

ACE AUTHENTICATION SERVER

CONFIGURING AN ACE AUTHENTICATION SERVER

Note: In order for the CyberSWITCH to reference an ACE server, the following configuration

steps must first be completed:

• basic IP routing information must be configured for ACE

• a LAN Network interface must be configured appropriately for the IP network

connected to each LAN port on the system

• at least one WAN Network Interface must be configured for ACE to be operable

After ACE configuration but before attempting to access the ACE Server, both the ACE

Server and the CyberSWITCH need to agree upon a “secret.” After configuring the ACE

server on the CyberSWITCH, issue the

sentry ace

system command. This command will

establish the necessary secret for communications between the two systems.

SING CFGEDIT

1. Select option (4), ACE from the Off-node Server Information menu. If you need guidance to

find this menu, refer to the instructions provided in the CSM Authentication Server

configuration section. The following screen will be displayed:

2. Select Primary Server and enter the following information:

a. IP address of the Authentication Server

b. UDP port number used by the Authentication Server

3. If your configuration includes an ACE Slave server, then select Secondary Server. Enter its IP

address. The UDP port number for the Master and Slave servers will be the same, regardless of

which server configuration screen from which it is entered.

4. Select Miscellaneous Information to finish the configuration.

a. Specify the number of access request retries that the system will send to the Authentication

Server.

ACE Authentication Server Menu:

Primary (Master) Server

is Not Configured

Secondary (Slave) Server

is Not Configured

Access Request

Number of Access Retries is 3

Time between Retries is 1 second

Encryption Method SDI

Source IP address is Not Configured

ACE Server Options:

1) Primary (Master) Server

2) Secondary (Slave) Server

3) Miscellaneous Information

4) Load ACE configuration file.

Select function from above or <RET> for previous menu:

1 2 ... 215 216 217 218 219 220 221 222 223 224 225 ... 728 729

Commentaires sur ces manuels

Pas de commentaire

Enterasys Networks CSX7000 Manuel d'utilisateur Page 220

Commentaires sur ces manuels