Central Site Remote Access Switch 453
V
ERIFYING
R
OUTING
P
ROTOCOLS
AppleTalk Routing
Below is an example of a configuration used to verify AppleTalk Routing operation. It uses
AppleTalk addresses, zones and resource names specific to the example. Substitute those of your
network when you perform the AppleTalk Routing feature verification steps.
APPLETALK ROUTING OVER THE LAN CONNECTION
1. Determine if the local Macintosh can see all zones. Bring up the Chooser on the Local Mac:
2. If a list of all zones (Left Zone and Right Zone) appear in the Chooser as shown above, then the
AppleTalk Routing over a LAN connection is operational. Continue with the next step.
3. If all zones are NOT displayed, then AppleTalk Routing over the LAN connection is not
operational, try the following:
ISDN
CSX5500
"Site1"
CSX1200
"Site2"
Net Range: 10-11
Zone: Left Zone
Net Range: 20-21
Zone: Right Zone
Local Mac Remote Mac
WORKGROUP REMOTE ACCESS SWITCH
LAN
10BASE-TRXTXSERVICE
CH-2
D-CH
CH-1
SYNC
POWER
LINE
1
CH-2
D-CH
CH-1
SYNC
LINE
2
CH-2
D-CH
CH-1
SYNC
LINE
3
CH-2
D-CH
AGI
CH-1
SYNC
LINE
4
Commentaires sur ces manuels