Enterasys Networks CSX7000 Manuel d'utilisateur télécharger pdf (Page 297)

100

101

Central Site Remote Access Switch 297

ONFIGURING

DVANCED

IP R

OUTING

IP Filters

CONFIGURING CONNECTION FILTERS

The IP Connection Filter is used at the point when an IP packet attempts to establish an outbound

connection in order to continue the forwarding process. Its configuration parallels that of

forwarding filters.

SING CFGEDIT

1. Select Connection Filter from the IP Filter menu.

2. Enable the Connection Filter. (By default, the Connection Filter is disabled.)

3. Select Edit the Connection Filter. A screen similar to the following will be displayed:

4. Select Add to add a condition.

5. Enter the name of the packet type to be forwarded. A screen similar to the following is then

displayed:

6. If the filter already has a forwarding condition (other than the final condition), an additional prompt

is presented concerning the condition’s position within the filter. Enter the location within the

filter where the condition is to be added:

• at the beginning

• at the end

• after the existing condition with id number “n”.

Note: If the Final Condition of the filter needs modification, do so via the Default Condition

selection on the Conditions for Filter menu. In this screen context, default condition refers to

final condition.

Conditions for "Connect_Filter"

Final Condition

DISCARD All Other Types

(1) Add, (2) Change, (3) Delete, (4) Move a CONDITION,

(5) Change Default Condition or press <RET> for previous menu?

Conditions for "Connect_Filter"

1 FORWARD "Type_Two"

Final Condition

DISCARD All Other Types

(1) Add, (2) Change, (3) Delete, (4) Move a CONDITION,

(5) Change Default Condition or press <RET> for previous menu?

1 2 ... 292 293 294 295 296 297 298 299 300 301 302 ... 728 729

Commentaires sur ces manuels

Pas de commentaire

Enterasys Networks CSX7000 Manuel d'utilisateur Page 297

Commentaires sur ces manuels