Enterasys Networks CSX7000 Manuel d'utilisateur télécharger pdf (Page 553)

100

101

Central Site Remote Access Switch 553

RACE

ESSAGES

PPP Packet Trace Messages

• Configure Request

The Configure Request is used to indicate the options that are supported by this

sending device. The Request contains an option list and the desired values if they are

different from the default value.

•Configure ACK

The Configure ACK is transmitted in response to a Configure Request. It indicates that

the sending device supports the options specified in the option list of the Configure

Request and that all values are acceptable. The receiving device assumes that

negotiation is complete for the Control protocol being configured.

•Configure NAK

The Configure NAK is transmitted in response to a Configure Request. It indicates that

the sending device understands, but does not accept the values of the options specified

in the option list of the Configure NAK. The option list of the NAK only contains the

unacceptable options. The receiving device should choose different options and send

another Configure Request with the new option list and values.

• Configure Reject

The Configure Reject is transmitted in response to a Configure Request. It indicates

that the sending device does not understand the options specified in the option list of

the Configure Reject. The option list of the Reject only contains the unknown options.

The receiving device must assume the sender cannot process the rejected options in

any manner, and take appropriate action. The Configure Reject inherently provides

backward compatibility with older PPP implementations.

• Terminate Request

The Terminate Request is transmitted when a device wishes to close down the

connection.

•Terminate ACK

The Terminate ACK is sent in response to a Terminate Request and indicates that the

sending device has closed the connection.

•Code Reject

The Code Reject is transmitted by a device if it does not recognize the PPP command

type received from the other device.

• Protocol Reject

The Protocol Reject is transmitted by a device if it does not recognize the PPP protocol

type received from the other device.

• Echo Request

The Echo request is used to provide a Data Link layer loop back detection mechanism.

The Echo Request packet contains the magic number of the sending device. Until the

magic number option has been negotiated the value must be set to zero.

1 2 ... 548 549 550 551 552 553 554 555 556 557 558 ... 728 729

Commentaires sur ces manuels

Pas de commentaire

Enterasys Networks CSX7000 Manuel d'utilisateur Page 553

Commentaires sur ces manuels