Enterasys Networks CSX7000 Manuel d'utilisateur Page 363

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 729
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 362
Central Site Remote Access Switch 363
C
ONFIGURING
A
PPLE
T
ALK
R
OUTING
AppleTalk Capacities
APPLETALK ROUTING STATIC ROUTES CONFIGURATION ELEMENTS
APPLETALK NETWORK TYPE
The AppleTalk network type used by the destination network of this static route. Type can be either
Extended Network or NonExtended Network.
D
ESTINATION NETWORK RANGE/NUMBER
The remote AppleTalk network range (for Extended network) or network number (for
NonExtended network) reachable through this static route entry.
N
EXT HOP DEVICE
The AppleTalk address of the next hop device that provides access to the destination AppleTalk
network. If the next hop is over an unnumbered WAN link, then the device name is specified. The
name must be a valid Device table entry.
N
UMBER OF HOPS
The number of AppleTalk routers that are traversed in order to reach the destination AppleTalk
network.
Z
ONE NAME(S)
The name of the zone(s) on the remote AppleTalk network.
APPLETALK ROUTING STATIC ROUTES BACKGROUND INFORMATION
You only need to configure static routing entries if you need to access a WAN network that is not
directly connected to the system, or if you need to access a LAN network through a router that does
not support AppleTalk RTMP. Static routes specify the AppleTalk address of the next hop router
that provides access to this network.
APPLETALK CAPACITIES
CONFIGURING APPLETALK CAPACITIES
USING CFGEDIT
1. Select AppleTalk Capacities from the AppleTalk Routing Menu.
2. Press 1 to set the maximum number of entries for the AppleTalk Route table.
3. Press 2 to set the maximum number of entries for the AppleTalk zone table.
APPLETALK CAPACITIES CONFIGURATION ELEMENTS
APPLETALK ROUTING TABLE MAXIMUM NUMBER OF ENTRIES
Allows you to set the maximum number of defined and learned routing table entries. The default
value is 512. The maximum is 2,000.
A
PPLETALK ZONE TABLE MAXIMUM NUMBER OF ENTRIES
Allows you to set the maximum number of defined and learned zone table entries. The default
value is 512. The maximum is 2,000.
Vue de la page 362
1 2 ... 358 359 360 361 362 363 364 365 366 367 368 ... 728 729

Commentaires sur ces manuels

Pas de commentaire