Enterasys Networks CSX7000 Manuel d'utilisateur Page 113

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 729
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 112
Central Site Remote Access Switch 113
C
ONFIGURATION
T
OOLS
Dynamic Management
Before using Dynamic Management commands, you must first enter the special Manage Mode by
typing the following command at the system prompt:
>manage
Once Manage Mode is entered, the prompt changes from [system name]> to [system name]:
MANAGE>. While operating in Manage Mode, only Dynamic Management commands are available.
All other system commands are ignored until you exit Manage Mode.
The <CTRL><C> key sequence will terminate the current command and return you to the
MANAGE> prompt. This is useful if you are in the process of responding to a series of prompts and
you wish to abort the command without responding to the remaining prompts.
Note: To use a command, you may enter the full command name as it appears in the HELP list,
or you may shorten the command to the point that it can still be distinguished from all
other Dynamic Management commands.
UTILITY DYNAMIC MANAGEMENT COMMANDS
There are several Manage Mode commands that are used for functions other than to configure the
system. They are as follows:
cls
Clears the display screen. This command is also available as an administration command.
help
The Manage Mode help command lists the available Dynamic Management commands and
instructs the user to enter the command followed by a question mark to see help information
for that specific command.
readme
Displays helpful tips on how to use the Dynamic Management commands.
SAVING DYNAMIC MANAGEMENT CHANGES
The Dynamic Management commands allow system data to be changed in real-time. These
changes take effect immediately upon the execution of the command and remain in effect until the
system is restarted. Once a software restart occurs, the changes are lost because the software reads
its initial system data values from a series of configuration files.
To prevent desired data changes from being overwritten by the restart process, the
commit
command should be executed. This command writes the current system data to the appropriate
disk files, thus making all changes permanent, even if the system software is restarted.
The
commit status
command displays the number of dynamic changes that have been made
using each Dynamic Management command since the last
commit
was performed.
To return to the normal operating mode after you have committed your changes, issue the
following command:
MANAGE>
exit
Vue de la page 112
1 2 ... 108 109 110 111 112 113 114 115 116 117 118 ... 728 729

Commentaires sur ces manuels

Pas de commentaire