Enterasys Networks CSX7000 Manuel d'utilisateur Page 564

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 729
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 563
USER’S GUIDE
564 CyberSWITCH
on the same subnetwork as the Telnet client on System 1’s LAN, a static route is needed to allow
System 2 to communicate with devices on Network 1. Because the CyberSWITCH had no Telnet
client capabilities in previous releases, the only way to fix the problem was to physically go to the
remote site and add a static route.
The second example network shown illustrates the current CyberSWITCH release. System 1 has
Telnet client capabilities, and therefore can simply Telnet to System 2 and add the needed static
route.
INSTALLATION AND CONFIGURATION
Telnet is available by default when IP routing is enabled. No installation or configuration steps are
required.
USAGE INSTRUCTIONS
To access the CyberSWITCH using Telnet, you must have a Telnet client software package. A
Telnet client software package is built into the CyberSWITCH. With the CyberSWITCH acting as
the Telnet client, simply enter the
telnet <ip address>
command to Telnet into the target
host. Refer to the System Commands chapter for a complete listing of available Telnet commands.
If you are using a PC or a workstation as a Telnet client, it must have a Telnet client software
package. From the Telnet client package, issue the command that will allow you to connect to the
Telnet Client
(Sub) Network 1
(Sub) Network 2
(Sub) Network 3
No route entry
configured to
Network 1
"SITE2"
"SITE1"
X
Can not communicate
"SITE1"
"SITE2"
Telnet Client
(Sub) Network 1
(Sub) Network 2
(Sub) Network 3
No route entry
configured to
Network 1
Can fix configuration problem
in SITE2 remotely
through SITE1
Remote Site
Remote Site
Telnet Client
CURRENT RELEASE:
EARLIER
RELEASES
:
ISDN
ISDN
CSX5500
CSX5500
CSX5500
CSX5500
Vue de la page 563
1 2 ... 559 560 561 562 563 564 565 566 567 568 569 ... 728 729

Commentaires sur ces manuels

Pas de commentaire