Enterasys Networks CSX7000 Manuel d'utilisateur télécharger pdf (Page 216)

100

101

USER’S GUIDE

216 CyberSWITCH

USING MANAGE MODE

offnode

Allows you to change current settings for off-node server options. You may use this command

to enable the RFC2138 compliance feature.

RADIUS TYPE CONFIGURATION ELEMENTS

RADIUS TYPE

Specify the type of RADIUS implementation: Cabletron implementation or RFC2138

implementation. For preexisting systems upgraded to UAA 7.3 software, the default is Cabletron

implementation. For new systems shipped with 7.3 software, the default is RFC2138.

BACKGROUND INFORMATION

The Cabletron RADIUS implementation allows the CyberSWITCH to perform device lookups in

RADIUS using MAC addresses, IP addresses, and other additional methods so that it can make

outbound calls using RADIUS. However, this implementation does not conform to RFC2138, in

which these “special” lookups are not permitted. The CyberSWITCH now provides an alternative

implementation to conform to the RFC2138 standard. This RFC2138 option disables RADIUS

lookups for outbound calls.

DYNAMIC DEVICE OPTION

This feature is specific to Terminal Mode configurations. Terminal Mode connections require both

device-level + user-level security configurations. With the Dynamic Device Option, you no longer

need to configure separate devices for each individual user. You may configure a single default

device which will apply to every user dialing in and authenticating with RADIUS, ACE, or

TACACS user-level security.

CONFIGURING THE DYNAMIC DEVICE OPTION

USING CFGEDIT

1. From CFGEDIT Main Menu, select (3) Security.

2. Select (5) Off-node Server Information.

3. Select Misc Off-node Server Options.

4. Check the current setting for Dynamic Device Option.

Note: If enabled, press <RET> to exit the menu. If disabled, select the Dynamic Device

Option function to enable the feature. (This selection is a simple toggle switch).

5. Return to the Misc Off-node Server Options Menu.

6. Select Dynamic Device Default Settings.

7. Provide a default device name.

8. Continue with the default device configuration just as you would for an on-node device entry.

(For more information on device entries, refer to the Current Device Table.)

1 2 ... 211 212 213 214 215 216 217 218 219 220 221 ... 728 729

Commentaires sur ces manuels

Pas de commentaire

Enterasys Networks CSX7000 Manuel d'utilisateur Page 216

Commentaires sur ces manuels