Enterasys Networks CSX7000 Manuel d'utilisateur télécharger pdf (Page 122)

100

101

USER’S GUIDE

122 CyberSWITCH

datalink delete

Deletes an existing data link.

LINE CONFIGURATION ELEMENTS

LINE NAME

A 1 to 16 user-defined character string (using all non-blank characters) that identifies the line. Each

line must have a unique name.

INE SLOT

The slot number assigned to the resource that will terminate this line.

INE PORT

The port number of the resource that will terminate this line.

INE INTERFACE TYPE

For basic rate lines only. Choice of point-to-point or point-multipoint. The point-to-point interface

type is the type most often used in the U.S.; point-multipoint is most often used in Japan.

UTO TEI

For basic rate lines only.The default setting for automatic TEI negotiation is “yes”. For #5ESS and

DMS100 lines, you should not change the setting. For NTT point-to-point lines, you should disable

the automatic TEI negotiation by answering “no” to the prompt for this feature.

ALL SCREENING METHODS

For basic rate lines only. If you select a line interface type of point-multipoint, choose one of the

following call screening methods: none, subaddress, or telephone number. The paragraphs below

define each method.

1. None

All calls will be accepted.

2. Subaddress

Uses a configured subaddress for this site. If the subaddress method is chosen, and a

subaddress has not been configured for this site, an error message will be displayed. You must

either choose another method, or configure a subaddress for this site.

3. Telephone Number

Telephone number(s) for your site used for call screening. Only calls directed to that specific

telephone number will be accepted. If there is more than one, enter the list of telephone

numbers separated by commas. After entering the telephone numbers, you will then be asked

to enter the maximum number of digits (starting at the rightmost digit) to be verified.

Note: If the telephone number(s) entered here do not exactly match the number(s) for the site,

you will be warned at this time. (The number of digits compared will be the number of

digits you chose to use for verification.)

ATA LINKS

A data link is a data communications link to the telephone switch. Your Carrier Service can provide

you with the data link values you need to configure. All switch types, except the DMS100 and the

NI-1, require a single data link per line. The NI-1 switch type can have either one or two data links

per line. The DMS100s generally require two data links per line, one for each B channel. For both

1 2 ... 117 118 119 120 121 122 123 124 125 126 127 ... 728 729

Commentaires sur ces manuels

Pas de commentaire

Enterasys Networks CSX7000 Manuel d'utilisateur Page 122

Commentaires sur ces manuels