Enterasys Networks CSX7000 Manuel d'utilisateur télécharger pdf (Page 579)

100

101

Central Site Remote Access Switch 579

YSTEM

OMMANDS

Viewing Operational Information

system prompt after the entire file has been displayed. If you are viewing the Release Notes,

press the

key to exit the release notes and continue with the installation.

If the file name is incorrect, the following message will be displayed:

Cannot find file "file name"

Displays the Connection Monitor screen. This screen provides information on the remote sites

to which the system is currently connected. The system updates the display as connections are

added or removed.

To display the Connection Monitor screen, Telnet and the terminal emulator must both be set

as the same terminal type. Use the

term set

command to do this.

Note: The

command is also available if you are remotely connected to the CyberSWITCH

by Telnet.

neif

This command will display the system interface table. This table provides information for each

of the system’s physical interfaces, including interface name, interface type, slot and port

number, and the operational status of each interface (up or down). This information can help

to determine system problems by identifying those physical interfaces that are not operating as

expected. Refer to the following example:

The definitions of the interface types and the associated status possibilities are as follows:

Ethernet

Each Ethernet port is considered an Ethernet interface. An Ethernet interface is “up” if the

Ethernet port is capable of forwarding packets to/from the LAN. An Ethernet interface is

“down” if the Ethernet port cannot be used to forward packets to/from the LAN.

Basic Rate (D-Channel)

Each Basic Rate line which contains at least one data link is considered a Basic Rate

(D-Channel) interface. A Basic Rate (D-Channel) interface is “up” if at least one data link

associated with the interface is “up.” A Basic Rate interface is “down” if none of the data

links associated with the interface is “up.”

Basic Rate (Permanent)

Each Basic Rate line which is used by a dedicated access is considered a Basic Rate

(Permanent) interface. A Basic Rate (Permanent) interface is “up” if the serial layer 1 is

“up” for the line. The dedicated access does not have to be “up” for the interface to be

considered “up”. A Basic Rate (Permanent) interface is considered to be down if the serial

layer 1 is “down” for the line.

[System Name]> NEIF

id Name Type Slot Port Status

-- ---- ---- ---- ---- ------

1 Ethernet Port 1 Ethernet 3 1 up

2 Ethernet Port 2 Ethernet 3 2 down

3 BRI.LINE.1 BRI D-Channel 1 1 up

4 BRI.LINE.1 BRI D-Channel 1 2 up

5 V.35.LINE V.35 2 1 down

1 2 ... 574 575 576 577 578 579 580 581 582 583 584 ... 728 729

Commentaires sur ces manuels

Pas de commentaire

Enterasys Networks CSX7000 Manuel d'utilisateur Page 579

Commentaires sur ces manuels