Enterasys Networks CSX7000 Manuel d'utilisateur télécharger pdf (Page 593)

100

101

Central Site Remote Access Switch 593

YSTEM

OMMANDS

Call Control Commands

To use this command for troubleshooting, you must use the System Call Trace feature to

capture any connect and disconnect messages that are generated by issuing the

call device

command. To do this:

1. Erase the current report log by entering

at the system prompt.

2. Enable the Call Trace feature by entering

trace on

at the system prompt.

3. Issue the

call device <device name>

command.

4. Display the system log messages by entering the

command at the system prompt.

5. Check the log report for connect messages relating to the remote device you are testing.

In response to the

call device <device name>

command, one of the following responses

will be displayed:

Calling device <device name>

Indicates that a call request process has been initiated.

<device name> could not be found in the Device Table

Indicates that the device name could not be found in the table of configured device names.

<device name> is already connected

Indicates that a connection to a device can not be initiated if there is already a connection

to that device. The call device command cannot be used to increase bandwidth for an

existing connection.

Call attempt failed

Indicates that the request could not be executed.

More than one match for <device name> found in the Device Table

Displayed if you enter just part of a device name and that part could specify more than one

device name. You will be prompted to enter the device name again, in a more specific

manner. For example, if

call device Sch

is entered, and there is a device configured

with the name Schultz, and a device configured with the name Schmidt, this message

would be displayed. You would then need to enter at least

call device Schu

successfully initiate a call to the device Schultz.

<device name> is not callable

Each PPP device in the device database can have one or two phone numbers at which they

can be called. This message is displayed if the device has no phone number specified.

Re-enter the name, or <RET> to cancel

The device name must be re-entered.

1 2 ... 588 589 590 591 592 593 594 595 596 597 598 ... 728 729

Commentaires sur ces manuels

Pas de commentaire

Enterasys Networks CSX7000 Manuel d'utilisateur Page 593

Commentaires sur ces manuels