Enterasys Networks CSX7000 Manuel d'utilisateur télécharger pdf (Page 100)

100

101

USER’S GUIDE

100 CyberSWITCH

4. Ensure that the administration console is properly connected to the administration port on the

CyberSWITCH.

5. Plug the power cord into a grounded electrical outlet.

6. Power on the CyberSWITCH by pressing the POWER-ON button.

7. Power on the administration console PC. After a few seconds, power-on initialization will

begin.

Initiating a Connection:

1. Execute Carbon Copy’s cchelp program which invokes Carbon Copy for guest operation.

2. Select Call CC Device <F1> from displayed menu.

3. Press <ENTER> or <RET>. (No telephone number is necessary since this is a local connection).

4. Carbon Copy will present you with a login prompt. Proceed to Establishing an Administrative

Session.

REMOTE CONNECTION USING TELNET

Telnet is available by default when IP routing is enabled on the CyberSWITCH.

Note: This type connection is not valid for first-time connections to the CyberSWITCH since you

need the CyberSWITCH’s IP address for access. However, it is a viable option for routine

system management and/or data transfer once initial installation and configuration have

been performed.

To access the CyberSWITCH using Telnet, you must have a Telnet client software package. A

Telnet client software package is built into the CyberSWITCH. With the CyberSWITCH acting as

the Telnet client, simply enter the

telnet <ip address>

command to Telnet into the target

host. Refer to the System Commands chapter for a complete listing of available Telnet commands.

If you are using a PC as a Telnet client, the PC must have a Telnet client software package. From

the Telnet client package, you will access the CyberSWITCH by connecting to the CyberSWITCH’s

IP address.

LAN access:

To access the CyberSWITCH you must set the device’s IP address to be on the same subnet as the

CyberSWITCH. Then place the CyberSWITCH on the LAN and Telnet to the address.

WAN access:

1. Connect the system to the (WAN) ISDN line.

2. From a remote device that supports unnumbered IP connections, dial in as a PPP CHAP device

USER1 (USER1 as secret). Provide Telnet with the CyberSWITCH address.

3. From a remote device only supporting numbered IP connections, set up an IP Address 2.2.2. 3

and have it dial as a PPP CHAP device USER2 (USER2 as secret). Provide Telnet with the

CyberSWITCH address of 2.2.2.2.

1 2 ... 95 96 97 98 99 100 101 102 103 104 105 ... 728 729

Commentaires sur ces manuels

Pas de commentaire

Enterasys Networks CSX7000 Manuel d'utilisateur Page 100

Commentaires sur ces manuels