Enterasys Networks CSX7000 Manuel d'utilisateur Page 450

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 729
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 449
USER’S GUIDE
450 CyberSWITCH
IPX ROUTING OVER A WAN CONNECTION
1. Determine if NetWare Client A can see the remote NetWare Server “remote. To do this,
activate NetWare Client A’s desktop network neighborhood feature. Then check to see if
“remote” is included in Client A’s network neighborhood.
2. If “remote” is included in Client A’s network neighborhood, them IPX over the WAN
connection is operational. If it does not appear in the network neighborhood, then IPX over the
WAN connection is not operational. Try the following:
a. Verify that the routing entry for the remote NetWare’s internal network exists by entering
the following command.
ipx route
If the route entry does not exist, add a static route to it using the
ipxroute add
command
(Manage Mode) because no route information (RIP packets) are exchanged over the WAN
connections.
b. Verify that the proper service entries of the remote NetWare server exist by entering the
following console command:
ipx service
If the proper service entries do not exist, add static services using the
ipxservice
com-
mand (Manage Mode) because no service information (SAP packets) are exchanged over
the WAN connections.
c. Verify that the CyberSWITCH has SAP processing enabled for the LAN interface by using
the
ixpnetif
command (Manage Mode). If the SAP processing is not enabled, change the
configuration for the network interface.
TRIGGERED RIP/SAP
1. Determine if triggered RIP/SAP has started by viewing the system messages. To display the
messages, enter the following console command:
dr <RET>
2. Look for following message among the system messages:
Starting Triggered RIP/SAP for <WAN Peer>
3. If this message is not displayed, try the following:
Verify that the WAN peer is properly configured. Issue the device command in Manage Mode
to display the current Device List. Or, you may view the WAN peer list through CFGEDIT,
Options, IPX Configuration, Triggered RIP/SAP. Be sure that the device (WAN peer) has IPX
routing enabled and triggered RIP/SAP (active) selected as routing protocol.
4. Determine if triggered RIP is operational. On the administration console, type:
ipx trigrip stats
5. Examine statistics for activity. Refer to Triggered RIP Statistics for possible statistics and their
descriptions.
Vue de la page 449
1 2 ... 445 446 447 448 449 450 451 452 453 454 455 ... 728 729

Commentaires sur ces manuels

Pas de commentaire