Enterasys Networks CSX7000 Manuel d'utilisateur télécharger pdf (Page 187)

100

101

Central Site Remote Access Switch 187

ONFIGURING

EVICE

EVEL

ATABASES

On-node Device Entries

If you select PVC, the list of available PVCs are displayed. The LCN of the selected PVC and

the X.25 Access Name are stored in the Device Table to bind the device to a particular virtual

circuit configuration:

If you select SVC, you must enter the X.121 address of the remote DTE. You need the remote

DTE address to make the X.25 call to the proper remote device.

8. For Digital Modem devices:

Begin by selecting Digital Modem from the Device Table Menu. The following menu will then

be displayed:

a. No change is necessary for Line Protocol. At this time, only PPP is available.

b. No change is necessary for Baud Rate. At this time, only Auto is available.

c. Select the line’s bearer capabilities.

d. Enter the phone number for this device.

Note: For detailed instructions on setting up your CyberSWITCH for Digital Modem usage,

refer to Configuring Other Advanced Options.

Select the type of the Virtual Circuit

1) Permanent Virtual Circuit (PVC)

2) Switched Virtual Circuit (SVC) [default 2]: 1

Current Permanent Virtual Circuits defined for X.25 Access #1, ’VMAX25’:

id Type LCN Protocol

-- ---- ---- --------

1 PVC 1 RFC877

2 PVC 2 RFC877

Id of Virtual Circuit to associate with device "vma",

or <RET> to cancel? 1

Select the type of the Virtual Circuit

1) Permanent Virtual Circuit (PVC)

2) Switched Virtual Circuit (SVC) [default 2]: 2

Enter the X.121 Address of the Remote DTE

or press <RET> to cancel? 9987654321

Device MODEM Menu: (device = "DAN")

1) Line Protocol "PPP (Point to Point Protocol)"

2) Baud Rate "Auto"

3) Bearer Capabilities "Speech"

4) Dial Out Phone Number(s) ""

Select function from above or <RET> for previous menu:

1 2 ... 182 183 184 185 186 187 188 189 190 191 192 ... 728 729

Commentaires sur ces manuels

Pas de commentaire

Enterasys Networks CSX7000 Manuel d'utilisateur Page 187

Commentaires sur ces manuels