Enterasys Networks CSX7000 Manuel d'utilisateur télécharger pdf (Page 186)

100

101

USER’S GUIDE

186 CyberSWITCH

6. For Frame Relay devices:

Note: You must first configure the Frame Relay Access. Instructions for configuring the

access is found in the Frame Relay Accesses section of the Configuring Alternate Accesses

chapter.

Begin by selecting Frame Relay from the Device Table Menu. A screen similar to the following

is displayed:

This screen will reflect your previously-configured access information for a permanent virtual

circuit associated with the device. This information is not configurable in this location.

Notes: If you receive the following message, ensure that the PVC Name matches the device

name.

No pvc configured for Device "DAN"

In order to associate a device to a specific PVC, you must also provide authentication

information (see step 9).

7. For X.25 devices:

Note: You must first configure the X.25 Access. Instructions for configuring the access is

found in the X.25 Accesses section of the Configuring Alternate Accesses chapter.

Begin by selecting X.25 from the Device Table Menu. If the X.25 access is configured for both

PVCs and SVCs, select the type of virtual circuit for the device:

Device Frame Relay Menu: (Device = "DAN")

Access Name DLCI Protocol

1) PVC Information DANACCESS 16 PPP

You cannot change this information from within this menu.

Press any key to continue

Select the type of the Virtual Circuit

1) Permanent Virtual Circuit (PVC)

2) Switched Virtual Circuit (SVC) [default 2]:

1 2 ... 181 182 183 184 185 186 187 188 189 190 191 ... 728 729

Commentaires sur ces manuels

Pas de commentaire

Enterasys Networks CSX7000 Manuel d'utilisateur Page 186

Commentaires sur ces manuels