Enterasys Networks CSX7000 Manuel d'utilisateur télécharger pdf (Page 539)

100

101

Central Site Remote Access Switch 539

YSTEM

ESSAGES

System Message Summary

Unable to send device information request to CSM after a terminal authentication.

Unable to send information to CSM. Verify proper configuration of CSM and Call Control options.

Unable to send DL Config Request

Unable to send DSL Config Request

Unable to send Terminate DSL Request

The above three messages indicate that an attempt has been made to dynamically update the Data

Link configuration, but the system is unable to send an update message down to a Basic Rate

adapter. Restart the system and review the configuration for the adapter. If the problem persists,

the indicated adapter card may be faulty. Contact your Distributor or Customer Support.

Unexpected error during transmission of LMI frame

A system error occurred during the actual transmit request for an LMI frame. Contact your

Distributor or Customer Support.

Unknown Calling Bridge <MAC address>

MAC address security is enabled and the remote Combinet does not match any of the defined

devices.

Unknown message type in SIG_get_rsc_inbound

Unknown message type in SIG_get_rsc_outbound

An error has been detected in the R2 signaling procedure, and will typically result in a failed call.

The error was due to unrecognizable or incorrect information. If problem persists, contact your

Distributor or Customer Support.

Unknown DLCI <dlci index> in CLLM message

The network has sent a CLLM message which has referenced the indicated DLCI that has not been

configured. Check the system configuration for the indicated DLCI.

Unknown Security Association

An incoming datagram specifies a Security Parameter Index (SPI) which has not been defined on

this node. Verify the encryption parameters on both nodes. Adjust if necessary so that both nodes

reflect the same SPI.

Unmatched Login Task

This represents an internal system error. Contact your Distributor or Customer Support.

Unsupported Combinet protocol received: <protocol Id>

An unsupported Combinet protocol attempted to connect to the system. Contact your Distributor.

You may need to upgrade software to support this.

Unsupported Combinet protocol version received: ‘<version Id>‘. [Device: <device name>]

An unsupported Combinet version attempted to connect to the system. Contact your Distributor.

You may need to upgrade software to support this.

Updating CyberSWITCH from “<FileName>”

The specified file, received during a Reliable Remote Upgrade, was successfully loaded into

memory and will now be verified before installation into the Flash File System.

1 2 ... 534 535 536 537 538 539 540 541 542 543 544 ... 728 729

Commentaires sur ces manuels

Pas de commentaire

Enterasys Networks CSX7000 Manuel d'utilisateur Page 539

Commentaires sur ces manuels