Enterasys Networks CSX7000 Manuel d'utilisateur télécharger pdf (Page 492)

100

101

USER’S GUIDE

492 CyberSWITCH

Cause <cause code> received for DLCI <dlci index>

A CLLM message was received indicating that the PVC associated with the indicated DLCI is

subject to the event denoted by the indicated cause code. These events are listed below with their

corresponding cause code:

CB disconnect:(1) Password Incorrect

CB disconnect:(2) Call-back number not found

CB disconnect:(3) Ethernet address inconsistent

CB disconnect:(4) Disconnecting for Call-back

CB disconnect:(5) Invalid Packet Received

CB disconnect:(6) Unable to resolve protocols

CB disconnect:(7) Inband Timeout

CB disconnect:(8) Line Integrity Violation

CB disconnect:(?) Unspecified

For all of the above Combinet generated messages, the Combinet has disconnected for the indicated

reason. Check your Combinet configuration, and adjust if necessary. If problem persists, contact

your Combinet distributor.

[CCP] Internal Decompression Failure

The system was unable to decompress a packet though the frame was delivered properly from a

protocol perspective. This is an unexpected condition with a properly functioning device

implementation and is thus considered a unrecoverable error. The system will close the CCP

protocol, meaning that the connection continues to operate, but in an uncompressed mode.

[CCP] Option Negotiation Failure, Non-Convergence detected

During PPP negotiation, the system attempted to negotiate CCP, but it was not possible to arrive

at a mutually acceptable set of protocol parameters with the connected device. The connection

continues to operate, but without compression.

The cause of this problem may result from:

• the system has too little memory to support compression, or

• the two devices involved don’t agree on which bridging/routing protocol to use (due to a mis-

configuration)

Check configuration for correct protocol. If this is not the problem, check memory availability.

CDR was unable to obtain a buffer to report a CDR event

A buffer was unavailable to send a call detail recording event log message, and the message was

discarded. This message is logged once when the condition first occurs. It will not be logged again

until the condition has been cleared and CDR has successfully obtained a buffer. If the condition

occurs again later, another message will be logged.

Cause Code Event

2 Mild congestion

3 Severe congestion

7 Fixed fault notification: facility/equipment

failure

10 Discard all frames: maintenance action in

progress

1 2 ... 487 488 489 490 491 492 493 494 495 496 497 ... 728 729

Commentaires sur ces manuels

Pas de commentaire

Enterasys Networks CSX7000 Manuel d'utilisateur Page 492

Commentaires sur ces manuels