Enterasys Networks CSX7000 Manuel d'utilisateur télécharger pdf (Page 445)

100

101

Central Site Remote Access Switch 445

ERIFYING

OUTING

ROTOCOLS

IP Routing Operational?

perform the verification steps. It also uses the

show ip route

command. The

show ip route

command is used by a specific router to display the IP routing table. Substitute the equivalent

command for your IP router.

1. Make sure that a dedicated connection between system and Router is up and operational. On

the system’s administration console:

Type:

2. Determine if Router has learned the route to 192.1.1.0 from the system. On the Router:

Type:

show ip route

If the route to 192.1.1.0 is displayed, the IP RIP output processing is operational.

3. If the route is NOT displayed, try the following:

a. Verify that the IP RIP Send Control is set to the proper RIP version that the Router can

understand. Refer to page 443 for instructions regarding check RIP versions.

b. Enter the

ip rip interface

administrative console command. Look for the Broadcast

Address value. This is the IP address of the router that the RIP messages are sent to.

c. If the address is not the correct address for the Router, correct the transmit broadcast

address for the interface using CFGEDIT. Refer to page 443 for instructions regarding

checking the address.

4. Enter the

ip rip stats

administrative console command. Look for the IfStatSentResponses

counter for the interface, which shows the number of RIP update messages sent on the

interface.

a. If the counter is 0, enter the

ip rip send

administrative console command to force the

RIP update message to be sent immediately.

b. Reissue the

ip rip stats

command. If the counter is still 0, there is an unexpected

condition present within the CyberSWITCH software. Contact Customer Support.

5. Check the Router and ensure that it is set up to learn route information via RIP.

IP RIP INPUT PROCESSING OPERATIONAL ON A WAN INTERFACE

To verify that IP RIP Input Processing (routes learning) is properly operational on a WAN interface,

the IP RIP processing must be successfully initialized.

Dedicated Connection

Router

192.1.1.1

100.1.1.1

100.1.1.2

192.1.2.1

CSX5500

1 2 ... 440 441 442 443 444 445 446 447 448 449 450 ... 728 729

Commentaires sur ces manuels

Pas de commentaire

Enterasys Networks CSX7000 Manuel d'utilisateur Page 445

Commentaires sur ces manuels