Enterasys Networks CSX7000 Manuel d'utilisateur télécharger pdf (Page 332)

100

101

USER’S GUIDE

332 CyberSWITCH

Static services are configured locally on the system. SAP entries are learned from incoming SAP

packets. All services are stored, used internally and advertised to other routers.

The same factors that affect the maximum number of routes stored also affect the maximum

number of services stored. Because of these factors, the maximum number of services for each

router must be configurable.

Each route or service entry requires memory. So increasing the number of entries may reduce the

amount of memory available for other system features (such as compression). Each 1KByte of

memory provides approximately 6 route entries or 4 service entries. If you configure the maximum

number of table entries allowable (3072), you will consume 471 KB for the routing table, and 639

KB for the service table.

We recommend you size both of these tables to be at least 10% larger than their steady-state size to

allow for network growth. However, you may choose a larger or smaller percentage, based on

memory availability.

PECIAL CONSIDERATIONS - REMOTE LAN INTERFACE

If using a router-to-router WAN interface, the routers at both ends participate in RIP and SAP

protocols. The routers intelligently process RIP and SAP messages and can be configured to only

send them when required. However, if using a Remote LAN interface, one end-point of the

connection is a bridge. The bridge does not understand RIP and SAP protocols; therefore, RIP/SAP

messages appear as background broadcast traffic. This traffic may cause dial-up links to remain

established for long periods of time. For more efficient operation, consider the following when

using a remote LAN interface:

• Link utilization parameters. Most bridges and routers allow you to configure link utilization

thresholds that determine how long a dial-up connection will stay up. If your dial-up link stays

up for longer than required, verify that the link utilization parameters are set properly for the

connection.

• Trace facilities. Many types of background traffic can keep the dial-up connection active. Using

a trace facility or traffic analyzer, determine what type of traffic is keeping the link up. If you

determine that RIP or SAP traffic is keeping the link up, consider the following:

a. If the remote LAN has only clients, consider setting the RIP and SAP settings on the

interface to Do Not Send, Receive and Respond. These settings will allow the system to

process the clients’ requests for servers, yet should prevent the system from keeping the

connection up unnecessarily. In addition, consider adding filters to the bridge (to prevent

any background traffic from devices on the remote LAN from keeping the line up), or

disable the devices’ ability to send such traffic in the first place.

b. If the remote LAN has any servers or routers, the situation becomes more difficult. In such

applications, we recommend a router-to-router WAN interface rather than a remote LAN

interface. However, if you still want to use a remote LAN interface, consider adjusting

throughput monitoring parameters on both peers to drop the connection when only RIP

and SAP activity is present. Or, disable RIP and SAP activity altogether and configure static

routes and services.

• If phone costs are of no concern, simply enable Send, Receive, and Respond for both RIP and

SAP.

1 2 ... 327 328 329 330 331 332 333 334 335 336 337 ... 728 729

Commentaires sur ces manuels

Pas de commentaire

Enterasys Networks CSX7000 Manuel d'utilisateur Page 332

Commentaires sur ces manuels