Enterasys Networks Smart 2200 Manuel d'utilisateur télécharger pdf (Page 34)

Connecting to the Network

3-8 Installation

Figure 3-5 2H258-17R Rear View

2. Observe the LANVIEW LEDs. After a successful boot, the PWR LED turns ON (green). If the

PWR LED is amber, there is no power redundancy. Check the power cord connections and the

power source. If there are no problems with the power cord connections or power source and the

PWR LED is still amber, contact Enterasys Networks. Refer to Section 1.2 for details.

3.4 CONNECTING TO THE NETWORK

This section provides the procedures for connecting fiber optic segments from the network or other

devices to the 2H258-17R.

Ports 1 through 16 on the 2H258-17R have MT-RJ connectors for multimode fiber optic cable

connections.

NOTE: If the 2H258-17R is being installed in a network using SmartTrunking, there are

rules concerning the network cable and port configurations that must be followed for

SmartTrunking to operate properly. Before connecting the cables, refer to the

SmartTrunk User’s Guide for the configuration information.

Primary

Redundant

26001-06

AC outlets are

on separate circuits

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 61 62

Pas de commentaire

Enterasys Networks Smart 2200 Manuel d'utilisateur Page 34