Enterasys Networks Smart 2200 Manuel d'utilisateur télécharger pdf (Page 25)

Network Requirements 2-1

Network Requirements

Before installing the 2H258-17R, review the requirements and specifications referred to in this

chapter concerning the following:

• SmartTrunk (Section 2.1)

• 100BASE-FX Twisted Pair Network (Section 2.2)

The network installation must meet the requirements to ensure satisfactory performance of this

equipment. Failure to do so will produce poor network performance.

2.1 SmartTrunk

To connect the 2H258-17R to a network so it can take advantage of the SmartTrunk feature, there

are certain rules concerning port connections and configurations that must be followed for proper

operation. Refer to the SmartTrunk User’s Guide for additional information.

2.2 100BASE-FX NETWORK

The fixed ports (1 through 16) of the 2H258-17R provide fiber optic multimode connections via

MT-RJ connectors. Segments connected to these ports must meet the optical performance

requirements for 100BASE-FX IEEE 802.3u. The front panel slot for optional modules can also

support Enterasys Networks fiber optic interface modules. The device at the other end of the

segment must meet the 100BASE-FX Fast Ethernet network requirements to operate at 100 Mbps.

Refer to the Enterasys Networks Cabling Guide for details.

NOTE: The SmartTrunk User’s Guide and Cabling Guide referred to in the following

sections can be found on the Enterasys Networks World Wide Web site:

http://www.enterasys.com/

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 61 62

Pas de commentaire

Enterasys Networks Smart 2200 Manuel d'utilisateur Page 25