Enterasys Networks Smart 2200 Manuel d'utilisateur télécharger pdf (Page 3)

NOTICE

Enterasys Networks reserves the right to make changes in specifications and other information contained in this

document and its web site without prior notice. The reader should in all cases consult Enterasys Networks to determine

whether any such changes have been made.

The hardware, firmware, or software described in this document is subject to change without notice.

IN NO EVENT SHALL ENTERASYS NETWORKS BE LIABLE FOR ANY INCIDENTAL, INDIRECT, SPECIAL,

OR CONSEQUENTIAL DAMAGES WHATSOEVER (INCLUDING BUT NOT LIMITED TO LOST PROFITS)

ARISING OUT OF OR RELATED TO THIS DOCUMENT, WEB SITE, OR THE INFORMATION CONTAINED IN

THEM, EVEN IF ENTERASYS NETWORKS HAS BEEN ADVISED OF, KNEW OF, OR SHOULD HAVE KNOWN

OF, THE POSSIBILITY OF SUCH DAMAGES.

Enterasys Networks, Inc.

35 Industrial Way

Rochester, NH 03867

Printed in the United States of America.

Part Number: 9033068-01 March 2003

ENTERASYS NETWORKS, ENTERASYS MATRIX, NETSIGHT, LANVIEW, MATRIX, WEBVIEW, and any logos

associated therewith, are trademarks or registered trademarks of Enterasys Networks, Inc. in the United States and other

countries.

All other product names mentioned in this manual may be trademarks or registered trademarks of their respective

companies.

FCC NOTICE

This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device

may not cause harmful interference, and (2) this device must accept any interference received, including interference that

may cause undesired operation.

NOTE: This equipment has been tested and found to comply with the limits for a class A digital device, pursuant to Part

15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference when the

equipment is operated in a commercial environment. This equipment uses, generates, and can radiate radio frequency

energy and if not installed in accordance with the operator’s manual, may cause harmful interference to radio

communications. Operation of this equipment in a residential area is likely to cause interference in which case the user

will be required to correct the interference at his own expense.

WARNING: Changes or modifications made to this device which are not expressly approved by the party responsible

for compliance could void the user’s authority to operate the equipment.

ELECTRICAL HAZARD: Only qualified personnel should perform installation

procedures.

1 2 3 4 5 6 7 8 ... 61 62

Pas de commentaire

Enterasys Networks Smart 2200 Manuel d'utilisateur Page 3