Enterasys Networks Smart 2200 Manuel d'utilisateur télécharger pdf (Page 43)

Troubleshooting Checklist

Troubleshooting 4-5

No Local

Management

Password screen.

Autobaud is enabled, but

the baud rate has not yet

been detected.

Press ENTER (RETURN) (may take up to

four times).

Terminal setup is not

correct.

Refer to the SmartSwitch Series 2E253,

2H252, 2H253, and 2H258 Local

Management User’s Guide for proper setup

procedures.

Improper console cable

pinouts.

Refer to Appendix A for proper console port

pinouts.

Corrupt firmware image,

or hardware fault.

If possible, attempt to download the image to

the 2H258-17R again. Refer to Section B for

instructions to clear NVRAM.

Cannot navigate

beyond Password

screen.

Improper Community

Names Table.

1. Refer to the SmartSwitch Series 2E253,

2H252, 2H253, and 2H258 Local

Management User’s Guide for Community

Names Table setup.

2. If you have forgotten the Community

Names, refer to Appendix B for

instructions on how to set the mode switch

to reset the Community Names to their

default values.

Table 4-2 Troubleshooting Checklist (Continued)

Problem Possible Cause Recommended Action

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 61 62

Pas de commentaire

Enterasys Networks Smart 2200 Manuel d'utilisateur Page 43