Enterasys Networks Smart 2200 Manuel d'utilisateur télécharger pdf (Page 18)

Overview

1-2 Introduction

The 2H258-17R is used to connect individual high-bandwidth user devices, such as workstations,

or to provide a central switching point for multiple 100-Mbps Fast Ethernet segments. The

optional HSIMs provide high speed uplinks to networking technologies such as Fast Ethernet,

Gigabit Ethernet, Fiber Distributed Data Interface (FDDI), Wide Area Network (WAN), and

Asynchronous Transfer Mode (ATM). Some HSIMs can provide additional Fast Ethernet ports in

varying media types. The optional VHSIMs provide very high speed uplinks to networking

technologies such as Gigabit Ethernet and ATM.

The 2H258-17R ports can be configured to control frame traffic in several ways, including

prioritizing traffic flow according to protocol type. The 2H258-17R can also be configured to

establish Virtual Local Area Networks (VLANs) and control the flow of frames associated with

each VLAN according to priority and Ether type. Detailed information about VLANs is provided

in the SmartSwitch Series 2E253, 2H252, 2H253, and 2H258 Local Management User’s Guide.

The 2H258-17R may be used as a tabletop unit or can be installed in a standard 19-inch rack using

the supplied rack mounting hardware.

The 2H258-17R has two power supplies. The power supplies load share 50% (+/-5%) of the power

required by the device. If one power supply fails, the remaining power supply assumes the entire

load of the device without interruption to network traffic. Each power supply module supports its

own ac input connection, which enables each power supply to be connected to a different ac power

circuit.

1.1.1 Connectivity

The 2H258-17R connects to Ethernet networks or workstations through the 16 fiber-optic

multimode MT-RJ ports on the front panel. These ports are in full compliance with the optical

performance requirements of 100BASE-FX version of IEEE 802.3u.The ports support multimode

fiber optic cables with 1300-nm surface emitting InGaAsP LEDs at lengths up to 2 kilometers for

100 Mbps.

The device also has a slot for an optional HSIM or VHSIM to provide additional connectivity to

various networking technologies.

1.1.2 Runtime IP Address Discovery

This feature enables the 2H258-17R device to automatically accept an IP address from a Boot

Strap Protocol (BootP) server on the network without requiring a user to enter an IP address

through Local Management.

When the device is connected to the network and powered up, Runtime IP Address Discovery

(RAD) checks the device for an IP address. If one has not yet been assigned (device IP address set

to 0.0.0.0), RAD checks to see if any of the device interfaces have a link. If so, RAD sends out

Reverse Address Resolution Protocol (RARP) and BootP requests to obtain an IP address from a

BootP server on the network.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 61 62

Pas de commentaire

Enterasys Networks Smart 2200 Manuel d'utilisateur Page 18