Enterasys Networks Smart 2200 Manuel d'utilisateur Page 29

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 62
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 28
Installing the Device
Installation 3-3
3.3 INSTALLING THE DEVICE
The 2H258-17R may be installed on a tabletop, shelf, or in a 19-inch rack. Section 3.3.1 describes
a tabletop or shelf installation and Section 3.3.2 describes the rackmount installation.
3.3.1 Tabletop or Shelf Installation
The following two subsections provide guidelines for installation on a tabletop or shelf.
Guidelines for Tabletop and Shelf Installations
Tabletop and shelf installations must be within reach of the network cabling and meet the
requirements listed below:
Locate the 2H258-17R within seven feet of an appropriately grounded power receptacle that
meets the power supply requirements listed in Appendix A.
In a shelf installation, the shelf must support 13.5 kg (30 lb) of static weight for each
2H258-17R.
Maintain a temperature of between 5°C (41°F) and 40°C (104°F) at the installation site with
fluctuations of less than 10°C (18°F) per hour.
Maintain a 2-inch clearance from the left, right, and rear sides of the device to provide adequate
ventilation.
Installation
For a tabletop or shelf installation, locate the 2H258-17R within seven feet of its power source and
on an unrestricted free surface area as shown in Figure 3-1. Proceed to Section 3.3.3 for power
connection instructions.
ELECTRICAL HAZARD: To prevent possible personal injury and/or damage to the unit,
do NOT connect power to the 2H258-17R until instructed to do so.
CAUTION: To ensure proper ventilation and prevent overheating, leave a minimum
clearance space of 5.1 cm (2.0 in) at the left, right, and rear of the 2H258-17R.
Vue de la page 28
1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 61 62

Commentaires sur ces manuels

Pas de commentaire