Enterasys Networks Smart 2200 Manuel d'utilisateur télécharger pdf (Page 32)

Installing the Device

3-6 Installation

Rack Mounting the 2H258-17R

Proceed as follows to install the 2H258-17R into a 19-inch rack:

1. There are several mounting holes in the rackmount brackets and the bottom of the chassis so that

each mounting bracket may be adjusted forward or backward to mount the device further into,

or out of the rack, depending on the installation requirements. Position the rackmount brackets

over the appropriate holes.

2. Locate the four 6-32 x 1/4-inch flathead screws in the rackmount kit. Use these screws to attach

the rackmount brackets to the bottom of the 2H258-17R as shown in Figure 3-3.

Figure 3-3 Attaching the Rackmount Brackets

3. With the mounting brackets attached, position the 2H258-17R between the vertical frame

members of the 19-inch rack and fasten it securely with mounting screws as shown in

Figure 3-4.

TELCO

CONSOLE

FAST ETHERNET WORKGROUP SWITCH

2H258-17R

COM

PWR

CPU

RESET

RX TX RX TX RX TX RX TX RX TX RX TX RX TX RX TX RX TX RX TX RX TX RX TX RX TX RX TX RX TX RX TX

123456 8910 151611 12 14137

Rackmount Bracket

Rackmount Bracket Screws

3068-04

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 61 62

Pas de commentaire

Enterasys Networks Smart 2200 Manuel d'utilisateur Page 32