Enterasys Networks C2K122-24 Manuel d'utilisateur télécharger pdf (Page 58)

Using LANVIEW

4-2 Troubleshooting

Using LANVIEW

TheswitchsupportstheEnterasys N etworksbuilt‐inLANVIEWLEDvisualdiagnostic

andstatusmonitoringsystem.ThelocationofeachC2K122‐24LANVIEWLEDisshown

inFigure 4 ‐1.TheLEDsenableyoutoquickly observenetworkstatusfordiagnosing

switchandnetworkproblems.

Figure 4-1 C2K122-24 LANVIEW LEDs

Table 4‐2describestheLEDindicationsand

providesrecommendedactionsas

appropriate.

1 CPU LED 6 Link/Activity LED for 10/100/1000 Mbps,

2 STACK DOWN LED port 1 of the 24 RJ45 ports

3 STACK UP LED 7 Link/Activity LEDs for 10-Gbps XFP ports,

4 RPS LED for redundant power-source status 25 and 26

5 Manager LED

Note: The terms flashing, blinking, and solid used in Ta ble 4-2 indicate the following:

Flashing: LED is flashing randomly.

Blinking: LED is flashing at a steady rate (approximately 50% on, 50% off).

Solid: LED is on steady and not pulsing.

Console

25 26

CPU

RPS

MGR

DOWN

25 26242322212019181716151413121110987654321

C2K122-24

TX RX TX RX

CPU

RPS

DOWN

MGR

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 69 70

Pas de commentaire

Enterasys Networks C2K122-24 Manuel d'utilisateur Page 58