Enterasys Networks C2K122-24 Manuel d'utilisateur Page 27

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 70
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 26
SecureStack C2 Installation Guide 2-1
2
Network Requirements
Beforeinstallingthedevice,reviewtherequirementsandspecificationsinthischapter
concerningthefollowing:
10BASE-TX Network
Whenconnectinga10BASETXsegmenttooneoftheRJ45 fixedports(1 through24),
ensurethatthenetworkmeetstheEthernetnetworkrequirementsoftheIEEE802.32002
standardfor10BASETX.RefertotheCablingGuidefordetails.
For information about... Refer to page...
10BASE-TX Network 2-1
100BASE-TX Network 2-2
1000BASE-T Network 2-2
10GBASE-XX Network 2-2
Note: The network installation must meet the requirements described in this chapter to
ensure satisfactory performance of this equipment. Failure to do so will produce poor
network performance.
Note: The associated switch configuration guide and the Cabling Guide referred to in the
following sections can be found on the Enterasys Networks World Wide Web site:
http://www.enterasys.com/manuals
For details about obtaining the manuals, refer to “Related Documents” on page xvi.
Note: If a port is to operate at 100 or 1000 Mbps, Category 5 cabling must be used.
Category 3 cabling does not meet the 100 or 1000 Mbps specifications. For 10 Mbps
operation only, Category 3, Category 4, or Category 5 cabling can be used. Refer to
100BASE-TX Network (page 2-2) and 1000BASE-T Network (page 2-2) for information
about 100BASE-TX and 1000BASE-T networks and cabling.
Vue de la page 26
1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 69 70

Commentaires sur ces manuels

Pas de commentaire