Enterasys Networks C2K122-24 Manuel d'utilisateur télécharger pdf (Page 42)

Configuring Switches in a Stack

3-12 Hardware Installation

Recommended Procedures for New and Existing Stacks

Installing a New Stackable System of Up to Eight Switches

Usethefollowingproceduretoinstallanewstackofuptoeightswitchesoutofthebox.

Beforeapplyingpower,makeallphysicalconnectionswiththestackcablesasdescribed

in“ConnectingHigh‐SpeedStackingCables”onpage 3‐9.

1. Onceallofthestackcableshavebeenconnected,individually

poweroneachswitch

fromtoptobottom(connectingpowertoaswitchisdescribedin“ConnectingACand

RPSPower” onpage 3‐13).

Iftheswitchesarepoweredonalmostsimultaneously,thesystem willautomatically

selectthefirstonethatpowersupastheManagerswitchandthe

othersasMember

switches.TheswitchesareassignedunitIDsintheorderthattheybecomefully

operational.

YoucancontroltheunitIDassignmentaccordingtothephysicalpositioninastack.

Whenyoupowerupeachswitchandallowittobecomefullyoperationalbefore

applyingpowertothe

nextswitch,thefirstonebecomestheManagerandallthenext

switcheswilljointhatstack(regardlessofPriority,FirmwareRevision,orMAC

Address).TheswitchesareassignedunitIDsintheorderthatyoupoweroneach

switch.

2. (Optional)Ifdesired,changethemanagementswitchusingthesetswitch



movemanagementcommandasdescribedintheSecureStackC2ConfigurationGuide.

3. OncethedesiredManagerswitchhasbeenselected,resetthesys temusingthereset

commandasdescribedintheSecureStackC2ConfigurationGuide.

Adding a New Switch to an Existing Stack

Usethefollowingproceduretoinstallanewswitchtoanexistingstackconfiguration.

Thisprocedureassumesthatthenewswitchbeingaddedhasacleanconfigurationfrom

manufacturingandisrunningthesamefirmwareimageversionasotherswitchesinthe

stack.

Important

The following procedures assume that all switches have a clean configuration from manufacturing.

When adding a new switch to an already running stack, it is also assumed that the new switch is

using the same firmware image version as other switches in the stack.

Note: Once switch IDs are assigned, they are persistent and will be retained during a

power cycle to any or all of the switches.

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 69 70

Pas de commentaire

Enterasys Networks C2K122-24 Manuel d'utilisateur Page 42