Enterasys Networks C2K122-24 Manuel d'utilisateur télécharger pdf (Page 60)

Using LANVIEW

4-4 Troubleshooting

UP Off No valid connection to switch stackdown

connector.

1. Make sure the switch connected to

the stackdown connector is powered

on.

2. Replace cable with a known good

one.

3. If the problem still exists, contact

Enterasys Networks for technical

support.

Green Solid. Valid connection to switch stackdown

connector.

Blinking. Information is being transferred over

the high-speed stacking cable.

None.

Manager Off Switch is operating as a Member in the stack. None.

Green Solid. Switch is operating as the Manager of the

stack.

None.

RPS Off RPS not in use.

Internal power supply failure.

None.

If an RPS is connected to the switch and

should be providing power, perform the

following:

1. Ensure the RPS is powered on.

2. Ensure that the AC power cord to the

RPS is plugged in correctly and that

there is power at the AC power

source.

3. Replace the power cord with a known

good one.

4. Ensure the DC power cord from the

RPS to the switch is plugged in

correctly.

5. If the problem persists, contact

Enterasys Networks for technical

support.

Amber Solid. The switch internal power supply failed,

and the RPS is providing the proper power to the

switch.

None.

Figure 4-2 LANVIEW LEDs (continued)

LED Color State Recommended Action

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 69 70

Commentaires sur ces manuels

Pas de commentaire

Enterasys Networks C2K122-24 Manuel d'utilisateur Page 60

Commentaires sur ces manuels