Enterasys Networks C2K122-24 Manuel d'utilisateur télécharger pdf (Page 36)

Installing the Switch on a Flat Surface

3-6 Hardware Installation

Figure 3-2 Chassis Bottom, Rubber Feet Placement

4. Removetheprotectivestripfromthe backofonerubberfootandpositionitona

markedlocationandpressfirmlyintoplace.Repeatthisproceduretoinstallthe

remainingthreerubberfeetintheotherthreelocations.

5. Afterinstallingtherubberfeet,returntheswitchtoitsuprightposition.

6. Proceed

to“GuidelinesforInstallation”onpage 3‐6.Forarackmountinstallation,

proceedto“RackMountingtheSwitch”onpage 3‐7.

Guidelines for Installation

Locatetheswitchwithin152cm(5ft)ofitspowersourceandonasurfaceasshownin

Figure 3‐3.Ifanoptionalredundantpowersystemisgoingtobeinstalledandconnected

tothe14‐pinRedundantPowerSupplyinputconnectorontherearoftheswitch,

referto

theinstallationguideshippedwiththeredundantpowersystem.

1 Bottom of chassis as seen when chassis is

resting on its back

3 Rubber feet with adhesive backing

(four)

2 Locations to install the rubber feet (four locations)

Note: If a number of switches are being installed in a stack, repeat steps 1 through 4 to

install the rubber feet on each switch before continuing with the installation.

ÂÂ

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 69 70

Pas de commentaire

Enterasys Networks C2K122-24 Manuel d'utilisateur Page 36