Enterasys-networks FN 100 Manuel d'utilisateur télécharger pdf (Page 41)

Performing Virtual Switching 3-3

FN100 Virtual Switching

Defining a Default Switch

By defining a default switch setting, you decide which of the FN100’s four virtual

switches will be recognized by Spanning Tree and reflected in the FN100 Bridge

Status window. When you change the default switch, only those ports which are

assigned to the selected default switch will be correctly displayed in the Bridge

Status window. All other ports will return an UNKNOWN bridge state.

To define a default switch for your FN100:

1. Click the I-bar cursor ( ) next to the Default Switch: field near the bottom of

the Virtual Switching window. The Change Default Switch window will appear.

Figure 3-2. The Change Default Switch Window

2. Enter the desired default switch number. Allowable entries are 1, 2, 3, or 4.

3. Click OK to select the default switch you have entered. Click Cancel to exit

the window without making any changes.

NOTE

When the FN100 is reset, all ports will revert to Virtual Switch #1. The Default Switch

will also revert to 1.

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 53 54

Pas de commentaire

Enterasys-networks FN 100 Manuel d'utilisateur Page 41