Enterasys-networks Fast Network 10 Manuel d'utilisateur télécharger pdf (Page 34)

Chapter 2: Unpacking and Installing Your FN10

Page 2-4 Fast Network 10 User Guide

Table 2-2 describes the FN10 buttons.

2.2 INSTALLING THE FN10

Table-mounting an FN10

If the FN10 is to be table-mounted, make sure you install the four stick-on

feet on the bottom of the unit, as shown in Figure 2-3. In addition, make

sure the unit is within reach of the network cables to which it will be

connected.

Figure 2-3 Installing the Stick-on Feet

Table 2-2 Description of FN10 Buttons

Button Function

Select

Cycles through the Segment Status options (TX, RX, Act,

Col, and Usr) for all ports. The lower port status LEDs of the

ports you are monitoring are activated based on what

function you chose with the Select button.

Reset Restarts the FN10.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 131 132

Pas de commentaire

Enterasys-networks Fast Network 10 Manuel d'utilisateur Page 34