Enterasys-networks Enterasys Gold Distributed Forwarding Engine 4H428 Manuel d'utilisateur télécharger pdf (Page 78)

Gaining Access to Memory Modules

B-8 Mode Switch Settings and Option Installations

2. RemovethetwoscrewsfasteningtheNEMtotheDFE‐Gold modulefrontpaneland

removethestandofffasteningtheNEMtothemainboard.Savethetwoscrewsand

standoffforlaterusetoreinstalltheNEM.

3. LiftandremovetheNEMoffthetwomainPCboardconnectors.Nowyou

have

accesstotheDRAMSIMM.ToreplacetheDRAMSIMM,proceedto“Removingthe

DRAMSIMM”.

Removing the DRAM SIMM

ToremovetheDRAMSIMM,refertoFigure B‐5andproceedasfollows.

1. RefertoFigure B‐5.PushtheconnectorarmsawayfromtheDRAMSIMMtoreleaseit

fromtheconnector.

2. RemovetheDRAMSIMMfromtheconnector.

Figure B-5 Removing the Existing DRAM SIMM

Note: The ejector arms on this connector are not spring-loaded, so they will remain in the

open position until manually closed.

1 Connector arms 2 Memory module 3 Connector

1 2 ... 73 74 75 76 77 78 79 80 81 82 83 ... 89 90

Pas de commentaire

Enterasys-networks Enterasys Gold Distributed Forwarding Engine 4H428 Manuel d'utilisateur Page 78