Enterasys Networks CSX7000 Manuel d'utilisateur télécharger pdf (Page 594)

100

101

USER’S GUIDE

594 CyberSWITCH

Unable to prompt for device name at this time

Indicates that the

call

command would prompt you for a device name, but the necessary

resources are not available. The recommended actions are as follows:

1. If possible, enter the device name on the command line.

2. If the device name cannot be entered from the command line (for example, the device

name contains command line delimiters of a space, a comma, a colon, or a tab), the user

can wait for a few minutes and see if any resources become available.

3. If actions 1 and 2 are ineffective, this may indicate an internal problem in the System,

please inform your service representative of the occurrence.

call peer <phone number> [data rate] [device] [bearer]

Initiates a call to a peer at the given number. Entering the data rate, device, and bearer is

optional. We describe each of the optional fields below.

data rate

The default data rate value for HDLC calls is 56Kbps. The default data rate for digital modem

calls is Auto.

device

The valid values are:

• HDLC: used for normal HDLC-ISDN calls

• DM: used for Digital Modem calls.

bearer

This field applies only to Digital Modem calls. The valid values are:

• SPEECH (the default if no bearer type is specified)

•3.1KHZ

The

call peer

command allows you to make a connection with another device. For example,

to call a site with the configured phone number of 13135552222 and a data rate of 64Kbps, you

would enter

call peer 13135552222 64.

To use this command for troubleshooting, you must enable the Call Trace feature to capture

any connect and disconnect messages that are generated by issuing the

call peer

command.

To do this:

1. Erase the current report log by entering

at the system prompt.

2. Enable the Call Trace feature by entering

trace on

at the system prompt.

3. Issue the

call peer <phone number> [data rate]

command.

4. Display the system log messages by entering the

command at the system prompt.

5. Check the log report for connect messages relating to the remote device you are testing.

In response to the

call peer

command, you will see the following message echoed back for

informational purposes:

1 2 ... 589 590 591 592 593 594 595 596 597 598 599 ... 728 729

Commentaires sur ces manuels

Pas de commentaire

Enterasys Networks CSX7000 Manuel d'utilisateur Page 594

Commentaires sur ces manuels