Enterasys Networks CSX7000 Manuel d'utilisateur télécharger pdf (Page 537)

100

101

Central Site Remote Access Switch 537

YSTEM

ESSAGES

System Message Summary

Too many digits in TN in HOST_CALL_REQUEST

(R2 Signaling) This illegal event typically results in a failed call. Contact your Distributor or

Customer Support.

Tried to free unallocated buffer <sub name>, size=<size>

Internal error that should be reported to Customer Support.

Transmit rate increased to <transmit rate>: Access <access index>, DLCI <dlci index>

The effective transmit rate has been increased to the indicated rate for the indicated DLCI under the

indicated access.

Transmit rate reduced to CIR <transmit rate>: Access <access index>, DLCI <dlci index>

The effective transmit rate has been limited to the Committed Information Rate which is the rate

for the indicated DLCI under the indicated access.

Type mismatch of configured & installed adapter #’x’

Configuration mismatch between the indicated adapter and the resource that was configured. The

system resource configuration should be corrected.

Unable to add dynamically-obtained device data into Device Table

The System authentication type is configured to obtain device information off-node. If such

information cannot be stored internally due to a temporary resource shortage, the call is dropped.

Unable to allocate IPX spoofing memory. IPX spoofing is being performed in a degraded mode.

The memory required by the IPX spoofing feature could not be allocated. The IPX spoofing code

will continue to run but it will run in a degraded mode. The default IPX spoofing options will

always be used when a connection is down to a device.

Unable to allocate port structure for port <port name> with address <AppleTalk Address>

Contact your Distributor or Customer Support.

Unable to allocate unnumbered wan port for device <device name>

Contact your Distributor or Customer Support.

Unable to complete Bridge Dial Out call: Insufficient information configured for Dial Out Device

Verify that Bridging and Make Calls for Bridge Data are enabled at the device level.

Unable to communicate with encryption board

Try again. If the problem persists, you may have a faulty encryption board. Replace the board.

Unable to Decrypt Datagram

An incoming datagram could not be decrypted. Verify encryption parameters on both nodes.

Unable to dynamically determine incoming call usage: Call Released.

This message refers to an incoming analog call which is going through the digital modem. The

digital modem has transferred the call to the AUD to determine type of call. The AUD did not

recognize any PPP LCP frames to transfer to the PPP stack, nor did it recognize the four carriage

returns it requires (within 5 seconds of connection) for remote analog console access.

If you are attempting remote analog console access, be sure to press the carriage return four times

within 5 seconds of making the connection.

1 2 ... 532 533 534 535 536 537 538 539 540 541 542 ... 728 729

Commentaires sur ces manuels

Pas de commentaire

Enterasys Networks CSX7000 Manuel d'utilisateur Page 537

Commentaires sur ces manuels