Enterasys Networks CSX7000 Manuel d'utilisateur télécharger pdf (Page 532)

100

101

USER’S GUIDE

532 CyberSWITCH

Successfully Loaded Release <X.Y> Issue <Z>

The specified release of System software was successfully loaded into memory.

Switch could not recognize phone number nnnnnnn

The switch did not accept the phone number dialed as a complete number. Check the correctness

of the phone number (including any leading digits such as 8 or 9).

System Clock Fault on Wan Adapter in Slot <slot #>

Indicates a TDM bus connection failure. Check to make sure that the TDM bus has been correctly

connected.

TACACS authentication is not available. You must first ENABLE TACACS user level authentication.

An attempt was made to configure the Terminal Server Security for TACACS and TACACS was

not configured on the CyberSWITCH.

TCP Connection to CSM at <IP address> is DOWN; reason: <reason code>.

The TCP connection to the Connection Services Manager (CSM) has gone down. Contact your

Distributor or Customer Support and provide them with the indicated reason code.

TCP Connection to CSM at <IP address> is UP.

A TCP connection exists between this device and the CSM at the indicated IP address.

TCP Connection to CSM Lost.

The TCP connection to the CSM has gone down.

TDM Clock Master changed TO (slot #, port#) FROM (slot #, port #)

The Clock Manager has dynamically adjusted the master clock source in response to an external

line state change.

Temporarily unable to read flash file system due to flash reclaim in progress - try again later

The system is automatically performing a flash reclaim to reclaim space previously occupied by

deleted files. Wait several seconds (up to a minute maximum) and try your file system command

again.

Terminal Server Security connections disabled. Dropping call.

The Terminal Server Security is set to none and a terminal connection was requested. Check

configuration. Most likely, the Default Async Protocol is set to terminal with no Terminal Server

Security configured.

Terminal Server Security is currently using this database. You must change the Terminal Server Security

setting first.

An attempt was made to disable a User Level Security Database when the terminal server was

configured to use this database for terminal mode authentication.

[TFTP] Data buffer allocated successfully

All parts of the TFTP feature (both Server and Client) were successfully initialized.

Note: The following “[TFTP] Local error...” messages generated during client operations will be

displayed on the console only and will not be logged to disk.

1 2 ... 527 528 529 530 531 532 533 534 535 536 537 ... 728 729

Commentaires sur ces manuels

Pas de commentaire

Enterasys Networks CSX7000 Manuel d'utilisateur Page 532

Commentaires sur ces manuels